Ignition switch, Push-button start switch Steering wheel control module, Intelligent access, Headlamp switchĭatalink connector, Steering wheel control module Keypad illumination, Brake shift interlock, Start button run indicator, Passive anti-theft system, Powertrain control module wake-up, Rear seat power enable Reverse lamps, Stop lamps, High-mounted stop lamp Left turn lamps, Left trailer tow tum/stop lamps Right turn lamps, Right trailer tow tum/stop lamps Interior courtesy lamps (overhead console, Second row, cargo), Puddle lamps, Console bin LED, Backlighting Run/accessory relay (wipers, rear washer), Rain sensor Interior demand lamps (overhead console, second row, cargo), Glove box lamp, Second and third row seat release, Visor lampsĤ-inch radio display, Power liftgate logic, Electronic finish panel, SYNC One-touch up and down passenger front window
#2014 ford explorer radio wiring driver
One-touch up and down driver front window To remove a fuse use the fuse puller tool provided on the fuse panel cover. Remove the panel cover to access the fuses. The fuse panel is located below and to the left of the steering wheel by the brake pedal. If a fuse blows again contact a qualified service center.Use always an intact fuse of the same color. Never replace a broken fuse with anything other than a new fuse.Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire. Always replace a fuse with one that has the specified amperage rating.Always disconnect the battery before servicing high current fuses.Before replacing fuses check that the key has been removed from the ignition and that all the services are switched off and/or disengaged.
0 kommentar(er)
